Murphysboro plumbers explain why pipes burst from freezing, pressure, and corrosion, and how to prevent them.
Murphysboro, United States - November 16, 2026 / A & W Plumbing and Heating, Inc. /
Avoid the Common Reasons Why Pipes Burst
A burst pipe can flood a home within minutes and lead to expensive water damage. Knowing why pipes burst makes it easier to prevent them and know when burst pipe repair is needed. This post covers the common causes of a pipe burst, including freezing, high water pressure, and corrosion, along with prevention tips for each.
Freezing
Water expands as it freezes, and that pressure can split a pipe. Frozen pipes are a leading cause of pipe bursts in cold weather, especially in exposed or uninsulated areas. Adding pipe insulation to exposed pipes in basements, crawl spaces, and exterior walls is one of the simplest ways to protect them.
Other steps can help prevent freezing pipes. Keep the indoor temperature steady, whether anyone is home or not. Leave kitchen and bathroom sink cabinet doors open so warm indoor air can reach the plumbing, and winterize outdoor faucets before the first hard freeze.
Pipes in unheated garages, attics, and exterior walls deserve extra attention, because they are the first to freeze. If a pipe freezes, don't ignore it, since a frozen section can split once it thaws and water begins to flow again.
High Water Pressure
Excessive water pressure puts constant strain on pipes, joints, and fittings. Over time, that strain can cause a pipe to burst. Scheduling annual plumbing maintenance lets a plumber check water pressure during the visit and correct it if needed before a pipe bursts.
It is also important to watch for warning signs. Loud banging or clanging from the pipes, called water hammer, can point to high water pressure. A professional should address it right away so it doesn't turn into a leak or a pipe-burst repair call. A pressure issue can be a quiet problem. Pipes may show no outward signs until a fitting or a pipe section gives way, which is why routine checks are more reliable than waiting for symptoms.
Corrosion
Pipes weaken as they age. Pipe corrosion thins the pipe walls, and corroded pipes are more likely to leak or fail without warning. Regular inspections as part of plumbing maintenance help find aging pipes, so they can be replaced before a burst occurs.
Rust-colored stains, flaking, or small leaks near joints can be early signs of corroded pipes. A plumber can tell whether a section needs attention now or can be monitored. If a pipe does burst, shut off the water immediately at the main water shut-off valve. Then open faucets to drain the remaining water and relieve trapped pressure. After that, call for burst pipe repair.
Acting quickly limits how much water spreads through the home. It also gives the plumber a safer starting point when repairs begin, whether the burst water pipe was caused by cold weather, pressure, or age.
Prevention works best as a combination of habits. Insulating pipes, keeping pressure in check, and scheduling plumbing maintenance each address a different cause, and together they lower the odds of a pipe burst. A plumber can review all three during one visit and point out which areas of the home are most at risk.
About A & W Plumbing and Heating, Inc.
A & W Plumbing and Heating, Inc. is a family-owned plumbing and heating company serving Murphysboro. They offer same-day service, personal attention, and 24/7 emergency service. Call for burst pipe repair services in Murphysboro, IL.
Contact Information:
A & W Plumbing and Heating, Inc.
11 Alliance Ave
Murphysboro, IL 62966
United States
Alicia Todd
(618) 687-5862
https://www.awplumbingil.com/
